Learn About The Standard Test Method For Fireproof Cables Together
Dec 01, 2021
Fireproof cable is one of many cables, so what is fireproof cable? Among the cable standards, there is a kind of fire protection standard, which is called "line integrity" standard. Its goal is to keep the cable unblocked in the fire, so that the power supply and information can still be transmitted normally. Therefore, cables that meet the requirements of series integrity are also called fireproof cables. The emergence of fireproof cables can effectively solve the problem that in case of fire, there can be enough time to transfer data information and minimize the possibility of data loss. There are three standard test methods for fireproof cables.
1. Standard Test Method for non flame retardation of single cable
Hang a section of tested single cable in a special burner, and the flame temperature acting on the cable reaches a certain value (exceeding the ignition temperature). After a few minutes, remove the fire source, and then observe whether the tested cable is self extinguishing.
2. Standard Test Method for flame retardant assessment of cable through holes
The United States, the Soviet Union and Japan have developed standard test methods for the flame retardancy of plugging materials for cable through holes. In a special heating furnace, the heating is applied to the plugging treatment of the cable through the furnace wall at one end of the tested cable according to the "time temperature" change speed specified in the standard temperature curve. After heating for 1-3H, observe that the cable section outside the furnace is incombustible or intact, To determine the flame resistance characteristics of plugging materials.
3. Standard Test Method for flame resistance of bundled cables
The basic principle is the same as that of the standard test method for non flame retardation of a single cable. Domestic wire and cable factories have built a complete set of test devices imitating the new iec382-2 standard, ieec-383 and ics-366 standards. The tests of simulated cable tunnel, cable shaft and cable interlayer are organized, and more reliable test data are obtained.







