Causes And Preventive Measures Of Common Insulation Faults Of Cables.
Nov 27, 2021
Even if the best quality wires and cables are selected, there will be some faults after a long operation time, so they should be found and solved in time to reduce losses. In fact, the most common fault of cables is insulation breakdown. The insulating layer is the insulating material layer between heating wires or between heating wires and grounding shielding layer, which has a great protective effect on cables, The quality of the insulation layer is also related to the quality of the cable. When the voltage borne by the insulation material exceeds a certain degree, or the insulation material is damaged, the insulation performance is lost, and the cable is lost of protection, it will also bring certain harm and loss. Therefore, we should select high-quality cable manufacturers for procurement, and protect the cable insulation layer and sheath.
Here are some reasons for breakdown:
The first is strong electrical breakdown. There are defects in the insulating material, such as impurities, voids, conductor tips, etc., which will cause electric field disproportion in the insulation and cause pulse discharge in the insulation. When the performance of insulating material decreases, the transfer of electronic energy occurs between the two conductors. For example, the ignition between high-voltage live wire and ground wire is discharge. Complete discharge is the instantaneous discharge, and a complete arc channel is formed between the two electrodes. Discharge is the cause of insulation breakdown of power cable. In the final analysis, the reason for strong electrical breakdown is the performance of insulating materials,
Secondly, for the convenience of transportation, the cable is severely squeezed during shipment, or the cable is hit by heavy objects and the bottom layer sinks during laying, the cable is under excessive tension during direct burial, and even the cable is accidentally injured by the excavator, which will lead to insulation damage and even pull the cable. This is mechanical damage.
Thirdly, in the process of installation and construction, the construction process of cable head is poor, so that water invades the inside of the cable or the inner protective layer of the cable is damaged, so that water enters. At the same time, due to the assembly environment, high humidity in summer, dry temperature in winter and other factors, the lead clad cable is laid near the earthquake source, resulting in fatigue cracking due to long-term vibration, and the cable skin is corroded to produce holes. It will not only damage the cable, but also endanger life safety.
Finally, the service life of high-quality cables is relatively long, but in the long-term operation of cables, due to poor heat dissipation or overload, the electrical and mechanical properties of insulating materials will age, and the insulating layer will become brittle or broken.
We all know the causes of cable breakdown, so we should take corresponding measures to prevent it. We should be careful in the process of cable handling and do not let the cable wear; Improve the construction quality. During the construction, the wrapping insulation must be tightened without voids or excessive bending. The epoxy resin and quartz powder must be strictly dried before use; Overhead cables, especially those laid along the wall, shall be covered; After the cable laying is completed, the patrol inspection of the cable line shall be strengthened during the operation, and the problems found shall be solved in time to prevent greater losses. The buried cables shall be marked to prevent being cut.







